Higher modes are not allowed for 16x16/chroma, which is what this
function is used for. Otherwise this function would return 0 (vertical
prediction) for invalid higher modes, which could result in invalid
reads.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC:libav-stable@libav.org
In this case we may not have a current frame, while first_field being
set implies we do.
Fixes invalid reads.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC:libav-stable@libav.org
There is no point in delaying the check and it avoids bugs with a
half-initialized context.
Fixes invalid reads.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC:libav-stable@libav.org
If it was set before then we can end up trying to decode a slice without
a valid slice header, which can lead to invalid memory access.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC:libav-stable@libav.org
This is a temporary workaround to allow deprecating
avcodec_get_frame_defaults(). The proper solution will be using a
properly allocated AVFrame in Picture.
Allow supporting files for which the image stride is smaller than
the maximum block size + number of subpel mc taps, e.g. a 64x64 VP9
file or a 16x16 VP8 file with -fflags +emu_edge.
This can be optionally disabled whith the "output_corrupt" flags
option. When in "output_corrupt" mode, incomplete frames are
signalled through AVFrame.flags FRAME_FLAG_INCOMPLETE_FRAME.
Signed-off-by: Anton Khirnov <anton@khirnov.net>
It is only used for error resilience. This allows building the
h264 decoder without dsputil, if error resilience is disabled.
Signed-off-by: Martin Storsjö <martin@martin.st>
The non-intra-pcm branch in hl_decode_mb (simple, 8bpp) goes from 700
to 672 cycles, and the complete loop of decode_mb_cabac and hl_decode_mb
(in the decode_slice loop) goes from 1759 to 1733 cycles on the clip
tested (cathedral), i.e. almost 30 cycles per mb faster.
Signed-off-by: Martin Storsjö <martin@martin.st>
Allows use of AVHWAccel based decoders with frame based multithreading.
The decoders will be forced into an non-concurrent mode by delaying
ff_thread_finish_setup() calls after decoding of the current frame
is finished.
This wastes memory by unnecessarily using multiple threads and thus
copies of the decoder context but allows seamless switching between
hardware accelerated and frame threaded software decoding when the
hardware decoder does not support the stream.
Error resilience is enabled by the h264 decoder, unless explicitly
disabled. --disable-everything --enable-decoder=h264 will produce
a h264 decoder with error resilience enabled, while
--disable-everything --enable-decoder=h264 --disable-error-resilience
will produce a h264 decoder with error resilience disabled.
Signed-off-by: Martin Storsjö <martin@martin.st>
